The DCT3TT digital programmable cycle timer is a programmable microprocessor timer with one or two outputs. The device offers the possibility to program up to

  • 3 setpoints
  • 5 operating modes for OUT1 output
  • 4 operating modes for OUT2 output
  • 4 time ranges (from max. 9999 hours to min. 0.1 sec.)
  • 4 timing function modes
  • 2 time counting modes (up and down)

The device can be connected to an external backup battery (9 V), which allows timing even in the event of a power failure.

The counting status is displayed on a four-digit display, while the status of the outputs is indicated by LEDs. The device can have 2 outputs (relay or transistor to control solid state relay - SSR) and 2 digital inputs for start timing (CNT EN) and reset - reset (RES), which can be voltage-free or potential (with potential equal to supply voltage) .

The device can be programmed with three buttons on the front panel, while timing can be done with the front button U or digital inputs CNT EN and RES on the rear terminal block.

Write a review

Note: HTML is not translated!
    Bad           Good

Digital programmable cyclic timer DCT3T

  • Brand: TECNOMEC
  • Product Code: EC309010
  • Availability: In Stock
  • 182.40 €

  • Ex Tax: 152.00 €

Related Products

Digital programmable thermostat with sensor

Digital programmable thermostat with sensor

Digital thermostat with two output relays allows to regulate the temperature in the range -50 ~ 99 °..

106.80 € Ex Tax: 89.00 €

Humidity and temperature transmitter AS109

Humidity and temperature transmitter AS109

The AS109 is a capacitive humidity and temperature transmitter that is characterized by its highly a..

475.20 € Ex Tax: 396.00 €

Digital humidity/thermometer controller IDHTC-W12

Digital humidity/thermometer controller IDHTC-W12

Intelligent digital humidity / thermometer controller IDHTC-W12. Digital humidity and thermometer co..

139.20 € Ex Tax: 116.00 €